Home › Engine / Hybrid System › F33A-FTV (FUEL) › FUEL INJECTOR › from 2021.07
RM38G0E _51 Engine / Hybrid System _106331 F33A-FTV FUEL _0492583 FUEL INJECTOR G

F33A-FTV FUEL  FUEL INJECTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23670 1.CHECK INJECTOR ASSEMBLY

a.

Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.


b.

Allow the engine to idle for 1 minute or more.


c.

Read the values when the engine is idling.

Powertrain > Engine > Data List
Tester Display
Target Injection Volume
Injection Feedback Value #1
Injection Feedback Value #2
Injection Feedback Value #3
Injection Feedback Value #4
Injection Feedback Value #5
Injection Feedback Value #6
50003 372 981,1410,1411,1412,1413,1414,1415

d.

Check that the "Injector Feedback Value. #1 to #4" values are within the specification.

Standard:
Tester Display Engine Condition Specified Condition
Target Injection Volume Idling 2.3 to 9.7mm3/st
Injector Feedback Value #1
Injector Feedback Value #2
Injector Feedback Value #3
Injector Feedback Value #4
Idling -4.9 to 4.9 mm3/st



e.

If the result is not as specified, replace the fuel injector assembly.