Home › General › SPECIFICATIONS › F33A-FTV ENGINE CONTROL › from 2021.07
RM38G0E _V1 General _100727 SPECIFICATIONS _0502416 F33A-FTV ENGINE CONTROL F

SPECIFICATIONS  F33A-FTV ENGINE CONTROL  SERVICE DATA  


DIESEL THROTTLE BODY
Tester Connection Test Condition Motor Resistance
5 (M-) - 6 (M+) 15 to 35°C (59 to 95°F) 1.28 to 1.48 Ω

ACCELERATOR PEDAL
Test Condition Accelerator Pedal Position Sensor No. 1 Accelerator Pedal Position Sensor No. 2
Release accelerator pedal 10 to 22% 24 to 40%
Depress accelerator pedal 52 to 90% 68 to 99%
Release and depress accelerator padal Value varies Value varies

MASS AIR FLOW METER
Test Condition Mass Air Flow
Idling (shift lever in N, engine warmed up and A/C off) EGR system ON 5.5 to 17.3 gm/sec
EGR system OFF 13.5 to 17.3 gm/sec
3000 rpm (shift lever in N, engine warmed up and A/C off) EGR system ON 38.0 to 124.4 gm/sec
EGR system OFF 81.7 to 124.4 gm/sec

MASS AIR FLOW METER (Intake Air Temperature Sensor)
Tester Connection Test Condition Specified Condition
4 (THA) - 2 (E2G) Always 0.47 to 19.3 kΩ

ENGINE COOLANT TEMPERATURE SENSOR
Tester Connection Test Condition Specified Condition
1 (E2) - 2 (THW) 20°C (68°F) 2.32 to 2.59 kΩ
1 (E2) - 2 (THW) 80°C (176°F) 0.310 to 0.326 kΩ

ENGINE COOLANT TEMPERATURE SENSOR (for Intercooler)
Tester Connection Test Condition Specified Condition
1 (E22) - 2 (THW2) 20°C (68°F) 2.32 to 2.59 kΩ
1 (E22) - 2 (THW2) 80°C (176°F) 0.310 to 0.326 kΩ

INTAKE AIR TEMPERATURE SENSOR (for Inlet Side)
Tester Connection Condition Specified Condition
1 (T3) - 2 (ET3) 25°C (77°F) 15.94 to 18.53 kΩ

INTAKE AIR TEMPERATURE SENSOR (for Outlet Side)
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) 25°C (77°F) 15.94 to 18.53 kΩ

MANIFOLD ABSOLUTE PRESSURE SENSOR
Tester Connection Test Condition Voltage
3 (VC) - 1 (E) Ignition switch ON 4.75 to 5.25 V

MANIFOLD ABSOLUTE PRESSURE SENSOR (for Secondary Compressor Outlet)
Tester Connection Test Condition Voltage
3 (VC) - 1 (E) Ignition switch ON 4.75 to 5.25 V

AIR FUEL RATIO SENSOR
Tester Connection Test Condition Specified Condition
1 (HA1A) - 2 (+B) 19 to 21°C (66 to 70°F) 1.6 to 3.2 Ω
3 (A1A+) - 4 (A1A-) - 1 MΩ or higher
3 (A1A+) - Sensor body - 10 MΩ or higher

RELAY
Item Tester Connection Test Condition Resistance
DCU MAIN RELAY (DCU) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
ELECTRONIC DRIVER UNIT RELAY (EDU) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
NO. 1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI MAIN NO. 1) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
NO. 2 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI MAIN NO. 2) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
NO. 3 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI MAIN NO. 3) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
FUEL FILTER RELAY (FUEL FIL) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
IGP RELAY (IGP NO.1) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
NO.2 IGP RELAY (IGP NO.2) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
IGR RELAY (IGR NO.3) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω
NITROGEN OXIDES RELAY (NOx) 3 - 5 - 10 kΩ or higher
Apply 12V across 1 and 2 Below 1 Ω