Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (w/o Emergency Call Service) › from 2022.11
RM38G0E _56 Audio / Visual / Telematics _100608 TELEMATICS _0562784 TELEMATICS SYSTEM(w/o Emergency Call Service) D

TELEMATICS  TELEMATICS SYSTEM(w/o Emergency Call Service)  VEHICLE CONTROL HISTORY (RoB)  


NOTICE:

Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.


CHECK VEHICLE CONTROL HISTORY


a.

Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55
Vehicle Control History Item
Code Tester Display Description Diagnostic Note
X2210 Life Cycle of DCM Backup Battery When the system detects that the mobilephone battery has reached the end of its lifespan.
·

The LED indicator light red indicator illuminates

·

Replace mobilephone battery

(Click here)

NOTICE:
·

After replacing the mobilephone battery, perform initialization.

·

After performing work, perform "CLEAR VEHICLE CONTROL HISTORY" to turn off the LED indicator light red indicator.




X2211 Low DCM Backup Battery Charge When the mobilephone battery charge is low. -
X2601 Software Inconsistency with ENG/HV Control Module The VIN number received via CAN communication does not match that stored in the DCM.
·

The LED indicator light red indicator illuminates

·

Perform VIN Synchronization

(Click here)


X2212 Diagnostics Communication Flow Failure Diagnostics communication flow failure (ID, Mode/SID difference). -
X2214 Communication Blackout from Power Distribution Controller ECU Lost Communication with Power Distribution box assembly Check CAN Communication System
(Click here)
X2215 Non Approval of the Reprograming User did not approve software update. -
X2216 Failure of the Reprogramming Software writing failed. -
X2217 Inconsistent Startup Software Software writing succeeded, but started software does not match package. -
X2218 Communication Blackout from Body Controller ECU Lost Communication with main body ECU (multiplex network body ECU). Check CAN Communication System
(Click here)
X221B Reached to the threshold count of accumulated current in IG-OFF In case accumulated current reaches specificated count threshold value. -
X21D3 DCM Abnormal behavior In case of DCM detects the abnormal behavior. -
X21D4 Reprograming Telematics ECU by OTA Start/Finish The software update of DCM by OTA is started and completed with success. -



CLEAR VEHICLE CONTROL HISTORY


NOTICE:

By performing this procedure, all stored Vehicle Control History will be cleared.


a.

Enter the following menus: Body Electrical / Telematics / Utility / Vehicle Control History (RoB).

Body Electrical > Telematics > Utility
Tester Display
Vehicle Control History (RoB)
50005 459 55

b.

According to the display on the GTS, clear the Vehicle Control History (RoB).