REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut and Join Location |
| *a | 240 mm (9.45 in.) | - | - |
| *A | LH Side | - | - |
| *A | RH Side | - | - |
| *A | for Australia (2016/08-) | - | - |
| *a | 240 mm (9.45 in.) | - | - |
| *A | for Australia (2016/08-) | *B | LH Side |
| *A | for Australia (2016/08-) | *B | RH Side |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *a | 240 mm (9.45 in.) | - | - |
Before temporarily installing the new parts, weld the back panel, back panel gusset, cab back reinforcement sub-assembly lower, back reinforcement lower, upper back panel bracket, tool bag band bracket, jack handle spring sub-assembly, front floor heat insulator bracket No.3 and clamp with the standard number of welding points.
| *1 | BACK PANEL | *2 | BACK PANEL GUSSET |
| *3 | CAB BACK REINFORCEMENT SUB-ASSEMBLY LOWER | *4 | BACK REINFORCEMENT LOWER |
| *5 | UPPER BACK PANEL BRACKET | *6 | TOOL BAG BAND BRACKET |
| *7 | JACK HANDLE SPRING SUB-ASSEMBLY | *8 | FRONT FLOOR HEAT INSULATOR BRACKET NO.3 |
| *9 | CLAMP | - | - |
| *A | LH Side | - | - |
| *A | RH Side | - | - |
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *A | for Australia (2016/08-) | - | - |
| *a | 240 mm (9.45 in.) | - | - |
Before temporarily installing the new parts, weld the back panel, cab back panel lower, cab back reinforcement sub-assembly lower, back reinforcement lower, upper back panel bracket, tool bag band bracket, jack handle spring sub-assembly, front floor heat insulator bracket No.3 and clamp with the standard number of welding points.
| *A | for Australia (2016/08-) | - | - |
| *1 | BACK PANEL | *2 | CAB BACK PANEL LOWER |
| *3 | CAB BACK REINFORCEMENT SUB-ASSEMBLY LOWER | *4 | BACK REINFORCEMENT LOWER |
| *5 | UPPER BACK PANEL BRACKET | *6 | TOOL BAG BAND BRACKET |
| *7 | JACK HANDLE SPRING SUB-ASSEMBLY | *8 | FRONT FLOOR HEAT INSULATOR BRACKET NO.3 |
| *9 | CLAMP | - | - |
| *A | for Australia (2016/08-) | - | - |
| *A | for Australia (2016/08-) | *B | LH Side |
| *A | for Australia (2016/08-) | *B | RH Side |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.