REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Brazing or Arc Brazing for Removal |
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
|
Adhesive | - | - |
| *A | for Australia (2016/08-) | - | - |
| *A | for Australia (2016/08-) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Braze |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).
Apply enough adhesive to the panels.
|
Adhesive | - | - |
| *1 | ROOF PANEL | - | - |
Before installing a new part, apply body sealer.
Apply body sealer in an even, continuous bead.
| *A | for Australia (2016/08-) | - | - |
| *A | for Australia (2016/08-) | ||
| *1 | ROOF PANEL | - | - |
| *A | for Australia (2016/08-) | - | - |
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.