Home › Vehicle Exterior › BODY PANEL › BODY LOWER BACK OUTER PANEL(for 2 Door Long Van)
BM25T0E _01 Vehicle Exterior _030570 BODY WELD POINT _0138539 BODY LOWER BACK OUTER PANEL(for 2 Door Long Van) F

BODY WELD POINT  BODY LOWER BACK OUTER PANEL(for 2 Door Long Van)  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K109026

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108819

Remove Weld Points
K108820

Remove Weld Points
K108827

Cut and Join Location

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K118247C01
2.01,2.229 2.323,2.385 0.313,0.156 10 false *a 5,2.24 5.313,2.396 0.313,0.156 10 false *a
*a 120 mm (4.72 in.) - -
K108837

Adhesive - -


K118248C01
0,0 0,0 false
K108837

Adhesive - -




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108824

Plug Weld
K108825

Plug Weld
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


c.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Apply a light coat of adhesive around the plug welding points.

·

Apply enough adhesive to the panels.



K118249C01
0,0 0,0 false
K108837

Adhesive - -


K118250C01
3.583,2.031 3.333,1.25 3.333,1.25 3.5,1.25 false 3.542,1.167 3.854,1.323 0.313,0.156 10 false *1
*1 BODY LOWER BACK PANEL SUB-ASSEMBLY - -


K118251


d.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.