Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING OR REPLACING PARTS › 2014.08–2019.09
BM25T0E _V1 General _030691 INTRODUCTION _0146344 WHEN REMOVING,INSTALLING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Note
ECM Register VIN DTC P0630 is output -
Supply pump initialization (for 1VD-FTV) Engine startability -
Fuel injector(s) (for 1VD-FTV) Injector compensationcode(s) registration DTC is output. -
Fuel supply pump (for 1VD-FTV) Supply pump initialization Engine startability -
·

Transponder key ECU assembly

·

ECM

·

Key


Registration Engine starting Refer to the Service Bulletin for the registration procedure.
·

Door control transmitter

·

Door control with receiver ECU assembly


Register recognition code Wireless door lock operation -
Timing belt (for 1HZ) Information mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


-