REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut and Join Location |
| *a | 200 mm (7.87 in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *A | LH | - | - |
| *a | 200 mm (7.87 in.) | - | - |
Before temporarily installing the new parts, weld the quarter panel and rear door open switch set retainer with the standard number of welding points.
| *A | LH | - | - |
| *1 | QUARTER PANEL | *2 | REAR DOOR OPEN SWITCH SET RETAINER |
If the entire supply part is not needed, remove the part of the supply part that is needed.
| *A | RH | - | - |
| *a | 200 mm (7.87 in.) | - | - |
Before installing a new part, apply body sealer.
Apply body sealer in an even, continuous bead.
| *A | RH | - | - |
Before temporarily installing the new parts, weld the quarter panel, rear door open switch set retainer and fuel inlet box with the standard number of welding points.
| *A | RH | - | - |
| *1 | QUARTER PANEL | *2 | REAR DOOR OPEN SWITCH SET RETAINER |
| *3 | FUEL INLET BOX | - | - |
| *A | RH | - | - |
| *1 | FUEL FILLER OPENING LID SUB-ASSEMBLY | - | - |
Before installing a new part, apply body sealer.
Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.
Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.
| *a | 5 mm (0.20 in.) | - | - |
Before installing a new part, apply body sealer.
Apply body sealer in an even, continuous bead.
After welding, apply body sealer to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.