CONSTRUCTION
Lightweight compact graphite iron is used for the cylinder block sub-assembly.
The cylinder block sub-assembly has a bank angle of 90°, a bank offset of 22 mm (0.866 in.) and a bore pitch of 97 mm (3.82 in.), resulting in a compact block in its length and width even for its displacement.
The oil pump drive gear at the rear end of the cylinder block sub-assembly drives the oil pump and the scavenging pump assembly in order to achieve a compact engine.
For details of the scavenging pump assembly, see the LUBRICATION (1VD-FTV) section.Engine / Hybrid System>1VD-FTV LUBRICATION>LUBRICATION SYSTEM>SCAVENGE OIL PUMP
4 plastic region tightening bolts are used to tighten the crankshaft bearing caps together with the cylinder block sub-assembly stiffening plates in order to reduce vibrations.
| *1 | Scavenging Pump Assembly | *2 | Oil Pump Drive Gear |
| *3 | Oil Pump Assembly | *4 | Cylinder Block Stiffening Plate |
| *5 | Crankshaft Bearing Cap | *6 | Plastic Region Tightening Bolt |