CONSTRUCTION
The function of the common-rail assembly is to store the fuel that has been pressurized by the supply pump. The common-rail assembly is provided with a fuel pressure sensor, which detects the fuel pressure in the common-rail assembly, and a pressure limiter that mechanically relieves the pressure in case the internal pressure of the common-rail rises abnormally.
Internally, the common-rail assembly contains a main hole and 5 branch holes that intersect the main hole. Each branch hole functions as an orifice that dampens the fluctuation of the fuel pressure.
The fuel pressure sensor outputs a signal that represents the fuel pressure in the common-rail assembly to the ECM in order to constantly regulate the fuel at an optimal pressure.
| *1 | Common-rail Assembly RH | *2 | Fuel Pressure Sensor |
| *3 | Common-rail Assembly LH | *4 | Pressure Limiter |
| *a | From Supply Pump | *b | To Injector Assembly |
| *c | To Common-rail Assembly LH | *d | To Fuel Tank (Excess Pressure) |
| *e | From Common-rail Assembly RH | - | - |
Fuel pressure sensor has its sealing portion plastic-deformed in order to keep sealing performance, so do not reuse it after disassembling.
The fuel pressure sensor and pressure limiter are supplied as a set with the common-rail assembly.
Do not disassemble the pressure limiter.
If parts that affect the alignment have been changed, make sure to replace the pipe with a new one as well. The parts that require the replacement of a pipe are listed below:
Injection Pipe: Injector, Common-rail, Cylinder Head and Intake Manifold
Fuel Inlet Pipe: Supply Pump, Common-rail, Cylinder Head and Intake Manifold
For details, refer to the Repair Manual.