CONSTRUCTION
The variable nozzle vane type turbocharger sub-assembly drives the vacuum type actuator according to the engine conditions, and controls the nozzle vane in order to achieve high engine output, low fuel consumption and low emissions.
The turbocharger sub-assembly is cooled by the water.
| *1 | Nozzle Vane | *2 | Actuator Linkage |
| *3 | Actuator | *4 | Impeller Wheel |
| *5 | Turbine Wheel | - | - |
The exhaust gas from the exhaust manifold goes through the nozzle vane inside the turbocharger housing and flows to the exhaust pipe through the turbine. The speed of the turbine (supercharging pressure) differs depending on the flow velocity of the exhaust gas going through the turbine and the flow velocity of the exhaust gas is controlled by the opening. When idling, the exhaust gas is less and the nozzle vane is fully closed, but as there is a slight clearance between the vanes, the exhaust gas flows through this clearance to the exhaust pipe. As this type of turbocharger has the nozzle vane operating in these ways, there is no bypass.
| *1 | Impeller Wheel | *2 | Nozzle Vane |
| *3 | Turbine Wheel | - | - |
| *a | To Exhaust Pipe | - | - |
|
Exhaust Gas |
|
Intake Air |
OPERATION
At Low Load Range or Low Speed Range
When the engine is running in a low load range or a low speed range, the actuator pulls up the actuator linkage. The actuator linkage is connected to the unison ring. At the same time, the drive arms installed in the unison ring move to change the nozzle vane angle toward the closing direction. As a result, the exhaust gas speed to the turbine increases, and the engine torque will be improved.
| *1 | Drive Arm | *2 | Actuator |
| *3 | Actuator Linkage | *4 | Turbine Wheel |
| *5 | Nozzle Vane | *6 | Unison Ring |
| *a | Exhaust Gas Flow | - | - |
At High Load Range or High Speed Range
When the engine is running in a high load range or a high speed range, the actuator pulls down the actuator linkage. With this, the drive arm moves and this opens the nozzle vane and holds the specified supercharging pressure. Thus, the exhaust gas back pressure is lowered, and the output and fuel consumption will be improved.
| *1 | Drive Arm | *2 | Actuator |
| *3 | Actuator Linkage | *4 | Turbine Wheel |
| *5 | Nozzle Vane | *6 | Unison Ring |
| *a | Exhaust Gas Flow | - | - |