Home › Engine / Hybrid System › 1GR-FE (ENGINE MECHANICAL) › ENGINE UNIT
NM25T0E _51 Engine / Hybrid System _029292 1GR-FE ENGINE MECHANICAL _0137842 ENGINE UNIT DE DETAILS F

1GR-FE ENGINE MECHANICAL  ENGINE UNIT  DETAILS  CYLINDER BLOCK  


CONSTRUCTION


a.

The cylinder block is made of aluminum alloy.


b.

The cylinder block has a bank angle of 60°, a bank offset of 36.6 mm (1.441 in.) and a bore pitch of 105.5 mm (4.15 in.), resulting in a compact block in its length and width even for its displacement.


c.

Spiny-type liners are used.


d.

The installation bosses of the two knock control sensors are located on the inner side of the left and right banks.

W100634C01
5.427,1.635 5.604,0.417 5.604,0.417 6.115,0.417 true 5.625,2.094 5.865,0.438 true 6.167,0.333 6.365,0.531 0.198,0.198 10 *1 4.094,3.021 4.688,3.25 0.594,0.229 10 36.6 mm 5.042,3.406 5.74,3.646 0.698,0.24 10 105.5 mm 1.135,0.906 1.49,1.104 0.354,0.198 10 60°
*1 Knock Control Sensor Boss - -



e.

A water passage is provided between the cylinder bores. By allowing the engine coolant to flow between the cylinder bores, this construction keeps the temperature of the cylinder walls uniform.

W100635C01
5.417,1.792 5.417,2.938 true 5.354,2.958 5.604,3.167 0.25,0.208 10 *1
*1 Water Passage - -



f.

The liners are the spiny-type which have been manufactured so that their casting exteriors form large irregular surfaces in order to enhance the adhesion between the liners and the aluminum cylinder block. The enhanced adhesion helps heat dissipation, resulting in a lower overall temperature and heat deformation of the cylinder bores.

W104386C01
1.74,1.313 1.625,0.906 1.625,0.906 1.521,0.906 true 4.969,2.188 4.74,1.802 4.74,1.802 4.635,1.802 true 5.74,1.708 5.979,1.708 true 5.344,1.479 5.26,1.219 5.26,1.219 5.167,1.219 true 1.365,0.802 1.563,1 0.198,0.198 10 false *1 2.625,1.531 2.823,1.729 0.198,0.198 10 false A 2.229,0.958 2.365,1.115 0.135,0.156 10 false A 5,1.125 5.198,1.323 0.198,0.198 10 false *1 6.021,1.615 6.219,1.813 0.198,0.198 10 false *2 4.458,1.719 4.656,1.917 0.198,0.198 10 false *3 5.427,2.615 5.625,2.813 0.198,0.198 10 false *a
*1 Cylinder Block *2 Liner
*3 Irregularly Shaped Outer Casting Surface of Liner - -
*a A - A Cross Section - -