FUNCTION OF MAIN COMPONENTS
The main components in the airbag system have the following functions:
| Components | Outline |
|---|---|
| Airbag Sensor Assembly | The airbag sensor assembly receives signals from the deceleration sensor, the safing sensor built into the airbag sensor assembly and one of the front airbag sensors, determines whether the driver airbag*1 and front passenger airbag*2 should be activated, and diagnoses system malfunctions. |
| Horn Button Assembly*1 | These consist of an inflator, a bag, and so on. The inflator deploys gas in accordance with an expansion signal from the airbag sensor assembly and deploys the bag. |
| Instrument Panel Passenger Airbag Assembly*2 | |
| Front Airbag Sensor | The front airbag sensor uses an electrical type deceleration sensor. Based on the deceleration of the vehicle during a frontal collision, a distortion is created in the sensor and converted into an electrical signal. Accordingly, the extent of the initial collision can be detected in detail. |
| Combination Meter Assembly
·
SRS Warning Light |
The SRS warning light turns on to alert the driver when the airbag sensor assembly detects a malfunction in the SRS airbag system. |
| ECM*3 | The ECM performs a fuel cut when the airbags are deployed. |
*1: Models with SRS driver airbag
*2: Models with SRS front passenger airbag
*3: Models with 1GR-FE engine
OPERATING CONDITION
If the impact of a collision is greater than the specified value, the SRS is activated automatically. The airbag sensor assembly includes the safing sensor and deceleration sensor. The safing sensor is designed to turn on at a lower deceleration rate than the deceleration sensor.
In case of a frontal collision, the airbag sensor assembly determines whether airbag deployment is necessary based on signals from the deceleration sensor and the front airbag sensor. If the safing sensor turns on simultaneously, current flows to the squibs to deploy the SRS components as shown in the illustration below. However, a deployment ignition signal may be output with the deceleration sensor ON signal even without a signal from a front airbag sensor.
SYSTEM CONTROL
Airbag for Frontal Collision
There are 2 types of airbags for frontal collisions: horn button assembly and instrument panel passenger airbag assembly. These airbags deploy simultaneously.
DIAGNOSIS
If the airbag sensor assembly detects a malfunction in the SRS airbag system, the airbag sensor assembly stores the malfunction data in memory, in addition to illuminating the SRS warning light.
The airbag sensor assembly outputs the malfunction data as 5-digit Diagnostic Trouble Codes (DTCs) to an intelligent tester II or the SRS warning light.
The 5-digit DTCs can be read after connecting the Global TechStream (GTS) to the DLC3. For details, refer to the Repair Manual.
If the SRS airbag deploys, the airbag sensor assembly will turn on the SRS warning light. However, in contrast to the ordinary diagnosis function, a DTC will not be stored. The SRS warning light cannot be turned off. After deployment, it is necessary to replace the airbag sensor assembly with a new one.