CONSTRUCTION
Heat-resistant steel is used for the intake and exhaust valves.
Unequal-pitch springs with anomalous cross sections are used to improve the surge resistance of the valve springs (inner compression spring).
The valve adjusting shim has been located directly above the valve lifter. This construction allows the valve adjusting shim to be replaced without removing the camshaft, which improves the serviceability during valve clearance adjustment. For details of valve clearance adjustment, refer to the Repair Manual.
Cutouts are provided in the valve lifter to improve the serviceability of the adjusting shims when replacement is required.
| *1 | Valve Adjusting Shim | *2 | Valve Spring Retainer |
| *3 | Valve Spring Retainer Lock | *4 | Valve Spring (Inner Compression Spring) |
| *5 | Valve | *6 | Valve Stem Oil Seal |
| *7 | Valve Lifter | *8 | Camshaft |
| *a | Spring Cross Section | *b | Cutout |