CONSTRUCTION
A compact and lightweight vane pump with built-in flow control valve, which uses die-cast aluminum as the material for its housing, is used. By optimizing its internal construction, this vane pump has achieved a low-friction operation, which leads to low fuel consumption.
A belt drive type vane pump is used on models with 1GR-FE engine, and a gear drive type vane pump is used on models with 1HZ or 1VD-FTV engine.
For the vane pump assembly and separate vane pump oil reservoir assembly, a cap has been integrated with the gauge to check the oil level in consideration of serviceability. Also, on models with 1GR-FE or 1VD-FTV engines, a partially transparent resin vane pump oil reservoir assembly is used to achieve weight reduction and improve fluid level visibility.
| *1 | Vane Pump Assembly | *2 | Pulley |
| *3 | Vane Pump Oil Reservoir Cap Sub-assembly | *4 | Vane Pump Oil Reservoir Assembly |
| *5 | Gauge | - | - |
| *a | Cross Section of Vane Pump | *b | Cross Section of Flow Control Valve |
| *1 | Vane Pump Assembly | *2 | Vane Pump Gear |
| *3 | Vane Pump Oil Reservoir Cap Sub-assembly | *4 | Vane Pump Oil Reservoir Assembly |
| *5 | Gauge | - | - |
| *a | Cross Section of Vane Pump | *b | Cross Section of Vane Pump Oil Reservoir |
| *c | Cross Section of Flow Control Valve | - | - |
| *1 | Vane Pump Assembly | *2 | Vane Pump Gear |
| *3 | Vane Pump Oil Reservoir Cap Sub-assembly | *4 | Vane Pump Oil Reservoir Assembly |
| *5 | Gauge | - | - |
| *a | Cross Section of Vane Pump | *b | Cross Section of Vane Pump Oil Reservoir |