CONSTRUCTION
The cylinder head sub-assembly is made of aluminum alloy.
The injector assembly has been located in the center of the combustion chamber in order to improve engine performance and clean emissions.
The passage for the EGR is provided in the cylinder head sub-assembly. By cooling the exhaust gas, a great amount of exhaust gas can recirculate.
A vertical 2-stage construction is used for the water jacket to improve cooling performance.
A glow plug assembly is placed between the intake ports of each cylinder to ensure startability.
| *1 | Cylinder Head Sub-assembly | - | - |
| *a | Injector Hole | *b | Intake Port |
| *c | Exhaust Port | *d | Glow Plug Hole |
| *e | EGR Passage | *f | 2-stage Construction Water Jacket |
An installation hole and fuel injection passage for the exhaust fuel addition injector assembly are provided on the cylinder head sub-assembly LH.*
*: Models compliant with EURO 5 emission regulations
| *1 | Cylinder Head Sub assembly LH | - | - |
| *a | Exhaust Fuel Addition Injector Assembly Installation Hole | *b | Injection Passage Cross Section |
| *c | To Exhaust Port | *d | Injection Passage |