CONSTRUCTION
The function of the common-rail assembly is to store the fuel that has been pressurized by the supply pump.
The common-rail assembly is provided with a fuel pressure sensor, which detects the fuel pressure in the common-rail assembly, and a pressure limiter that mechanically relieves the pressure in case the internal pressure of the common-rail rises abnormally.
Internally, the common-rail assembly contains a main hole and 5 branch holes that intersect the main hole. Each branch hole functions as an orifice that dampens the fluctuation of the fuel pressure.
The fuel pressure sensor outputs a signal that represents the fuel pressure in the common-rail assembly to the ECM in order to constantly regulate the fuel at an optimal pressure.
A fuel pressure discharge valve is used.*
The fuel pressure discharge valve regulates the fuel pressure within the fuel pressure range normally. In the fuel pressure discharge valve, the plunger opens and closes in accordance with the actuation signals from the injector driver. Thus, it regulates pressure by releasing excess pressure from the common-rail assembly.*
*: Models compliant with EURO 5 emission regulations
| *1 | Common-rail Assembly RH | *2 | Fuel Pressure Sensor |
| *3 | Common-rail Assembly LH | *4 | Pressure Limiter |
| *a | From Supply Pump Assembly | *b | To Injector Assembly |
| *c | To Common-rail Assembly LH | *d | To Fuel Tank Sub-assembly (Excess Pressure) |
| *e | From Common-rail Assembly RH | *f | A - A Cross Section |
| *g | B - B Cross Section | *h | Branch Hole |
| *1 | Common-rail Assembly RH | *2 | Fuel Pressure Sensor |
| *3 | Common-rail Assembly LH | *4 | Pressure Limiter |
| *5 | Fuel Pressure Discharge Valve | - | - |
| *a | From Supply Pump Assembly | *b | To Injector Assembly |
| *c | To Common-rail Assembly LH | *d | To Fuel Tank Sub-assembly (Excess Pressure) |
| *e | From Common-rail Assembly RH | *f | A - A Cross Section |
| *g | B - B Cross Section | *h | Branch Hole |
Fuel pressure sensor has its sealing portion plastic-deformed in order to keep sealing performance, so do not reuse it after disassembling.
The fuel pressure sensor, pressure limiter and fuel pressure discharge valve* are supplied as a set with the common-rail assembly.
Do not disassemble the pressure limiter.
Do not disassemble the fuel pressure discharge valve.*
If parts that affect the alignment have been changed, make sure to replace the pipe with a new one as well. The parts that require the replacement of a pipe are listed below.
Injection Pipe: Injector Assembly, Common-rail Assembly, Cylinder Head and Intake Manifold
Fuel Inlet Pipe: Supply Pump Assembly, Common-rail Assembly, Cylinder Head and Intake Manifold
For details, refer to the Repair Manual.
*: Models compliant with EURO 5 emission regulations