13711 1.REMOVE VALVE
Arrange the valves, inner compression springs, valve spring retainers and valve spring retainer locks in the correct order.
Place the cylinder head sub-assembly on a wooden block.
Using SST, compress the inner compression spring and remove the valve spring retainer lock.
Remove the valve spring retainer, inner compression spring and valve.
13711A 2.REMOVE VALVE STEM OIL SEAL
Using pliers, remove the valve stem oil seal.
13734 3.REMOVE VALVE SPRING SEAT
Using compressed air and a magnet hand, remove the valve spring seats by blowing air.
23699A 4.REMOVE NOZZLE HOLDER CLAMP SEAT
Remove the 4 nozzle holder clamp seats.
11117E 5.REMOVE NO. 1 STRAIGHT SCREW PLUG WITH HEAD
| *A | for Bank 1 |
| *B | for Bank 2 |
Using a 6 mm hexagon wrench, remove the No. 1 straight screw plug with head and gasket.
6.REMOVE CYLINDER HEAD STUD BOLT
If a cylinder head stud bolt is deformed or the threads are damaged, replace it.