1.INSTALL CYLINDER HEAD STUD BOLT
If a cylinder head stud bolt is deformed or the threads are damaged, replace it.
Using an E8 "TORX" socket wrench, install the cylinder head stud bolts.
11117E 2.INSTALL NO. 1 STRAIGHT SCREW PLUG WITH HEAD
Using a 6 mm hexagon wrench, install a new gasket and the No. 1 straight screw plug.
23699A 3.INSTALL NOZZLE HOLDER CLAMP SEAT
Install the 4 nozzle holder clamp seats.
13734 4.INSTALL VALVE SPRING SEAT
Install the valve spring seats to the cylinder head sub-assembly.
13711A 5.INSTALL VALVE STEM OIL SEAL
| *1 | Cylinder Head Sub-assembly |
| *a | CORRECT |
| *b | INCORRECT |
Apply a light coat of engine oil to a new valve stem oil seal and valve guide.
Using SST, push in the valve stem oil seal.
Below 14.7 mm (0.579 in.)
13711 6.INSTALL VALVE
| *a | 50 mm (1.97 in.) |
Apply plenty of engine oil to the tip area of the valve shown in the illustration.
Place the cylinder head sub-assembly on a wooden block.
Install the valve, inner compression spring and valve spring retainer to the cylinder head sub-assembly.
Install the same parts in the same combination to their original locations.
Using SST, compress the inner compression spring and place the valve spring retainer lock around the valve stem.
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
Be careful not to damage the valve stem tip.