Home › Engine / Hybrid System › 1GR-FE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM
RM25T0E _51 Engine / Hybrid System _029208 1GR-FE EMISSION CONTROL _0132959 EMISSION CONTROL SYSTEM G

1GR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650G 1.CHECK PURGE VSV

a.

Connect the GTS to the DLC3.


b.
A316743

Slide the clamp and disconnect the No. 1 fuel vapor feed hose (connected to the charcoal canister assembly) from the purge VSV.


c.

Start the engine and turn the GTS main switch on.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VSV for Evap Control
50004 61 6
OK:
Tester Operation Specified Condition
VSV is OFF Purge VSV has no suction
VSV is ON Purge VSV has suction



e.

Connect the No. 1 fuel vapor feed hose (connected to the charcoal canister assembly) to the purge VSV, and slide the clamp to secure the hose.


Hide 2.INSPECT FUEL CUT-OFF RPM

a.

Start and warm up the engine.


b.

Increase the engine speed to at least 3500 rpm.


c.

Use a sound scope to check for fuel injector assembly operation noise.


d.

Check that when the accelerator pedal is released, the fuel injector assembly operation noise stops momentarily and then resumes.

If the result is not as specified, check the fuel injector assembly, wiring and ECM.


Hide 3.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Check that there are no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap sub-assembly, PCV hose and other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in the parts of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If the result is not as specified, replace parts as necessary.


Hide 4.CHECK HOSES AND CONNECTORS

a.

Visually check for loose connections, sharp bends or damage.


Hide 77100 5.CHECK FUEL TANK ASSEMBLY

a.

Visually check for deformation, cracks or fuel leakage.