Home › Engine / Hybrid System › 1GR-FE (EMISSION CONTROL) › PURGE VALVE
RM25T0E _51 Engine / Hybrid System _029208 1GR-FE EMISSION CONTROL _0132961 PURGE VALVE G

1GR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 17650G 1.INSPECT PURGE VSV

a.

Inspect the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - Body ground Always 10 MΩ or higher
2 - Body ground


If the result is not as specified, replace the purge VSV.



b.

Check the operation of the purge VSV.

i.
A316752C01
0.667,0.667 0.833,0.667 0.833,0.667 1.167,1.167 true 1.75,1.833 1.75,1.188 true 0.51,0.573 0.823,0.729 0.313,0.156 10 false *a 1.677,1.844 1.99,2 0.313,0.156 10 false *b 0.833,1.229 1.146,1.385 0.313,0.156 10 false *c 2.76,1.688 3.073,1.844 0.313,0.156 10 false *d
*a Port F
*b Port E
*c Does not flow
*d Air


Check that air does not flow from port F when air is applied to port E.


ii.
A316753C01
0.333,0.583 0.5,0.583 0.5,0.583 0.74,1.115 true 1.292,1.771 1.292,1.104 true 1.813,0.969 1.917,0.25 1.917,0.25 2.083,0.25 true 1.802,1.073 2,1.333 2,1.333 2.167,1.333 true 0.177,0.479 0.49,0.635 0.313,0.156 10 false *a 1.229,1.781 1.542,1.938 0.313,0.156 10 false *b 2.177,1.719 2.49,1.875 0.313,0.156 10 false *c 2.125,0.156 2.281,0.323 0.156,0.167 10 false 1 2.198,1.24 2.406,1.417 0.208,0.177 10 false 2
*a Port F
*b Port E
*c Air


Apply battery voltage to the connector and check the purge VSV operation.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
Air flows from port E to port F


If the result is not as specified, replace the purge VSV.