Home › Power Source / Network › 1GR-FE (BATTERY / CHARGING) › GENERATOR
RM25T0E _57 Power Source / Network _029236 1GR-FE BATTERY / CHARGING _0133251 GENERATOR G

1GR-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

A138091

a.

Using a vernier caliper, measure the exposed brush length.

Standard brush length:

10.5 mm (0.413 in.)


Minimum brush length:

4.5 mm (0.177 in.)


If the exposed brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.

Check the rotor for an open circuit.

i.
A296802C06
0.667,1.146 0.292,0.792 0.292,0.792 0.781,1.104 true 0.115,0.708 0.427,0.865 0.313,0.156 10 false *a
*a Slip Ring


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.85 to 2.25 Ω


If the result is not as specified, replace the generator rotor assembly.


ii.
A296803C06
0.188,0.979 0.323,0.979 0.323,0.979 0.365,1.156 true 1.281,0.813 1.625,0.448 1.625,0.448 1.875,0.448 true 0.021,0.906 0.333,1.063 0.313,0.156 10 false *a 1.906,0.365 2.219,0.521 0.313,0.156 10 false *b
*a Slip Ring
*b Rotor Core


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 kΩ or higher


If the result is not as specified, replace the generator rotor assembly.



b.
A196744

Check that the generator rotor bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


c.

Check each slip ring.

i.

Check that the slip rings are not rough or scored.

If rough or scored, replace the generator rotor assembly.


ii.
A297149

Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.