Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › TIMING BELT
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133477 TIMING BELT G

1HZ ENGINE MECHANICAL  TIMING BELT  INSPECTION  


PROCEDURE

Hide 13568 1.INSPECT TIMING BELT

NOTICE:
A327191C01
1.927,0.375 2.156,0.583 0.229,0.208 10 false *a 2.813,0.198 3.063,0.375 0.25,0.177 10 false *b
*a Oil
*b Water


·

Do not bend or twist the timing belt, or turn it inside out.

·

Do not allow the timing belt to come into contact with oil, water or steam.



a.

If there is premature parting:

·

Check for proper installation.

·

Check the timing cover gasket for damage and proper installation.



b.

If the belt teeth are cracked or damaged, check if either camshaft is locked.


c.

If there is noticeable wear or cracks on the belt face, check if there are nicks on the side of the idler pulley lock and engine water pump assembly.


d.

If there is wear or damage to only one side of the belt, check the belt guide and the alignment of each pulley.


e.

If there is noticeable wear on the belt teeth:

·

Check the timing cover for damage.

·

Check that the gasket has been installed correctly.

·

Check for foreign matter on the pulley teeth.


If necessary, replace the timing belt.


Hide 13505 2.INSPECT NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

a.
A326327

Visually check the seal portion of the No. 1 timing belt idler sub-assembly for oil leakage.

If leakage is found, replace the No. 1 timing belt idler sub-assembly.


b.
A326328

Check that the No. 1 timing belt idler sub-assembly turns smoothly.

If necessary, replace the No. 1 timing belt idler sub-assembly.


Hide 13540 3.INSPECT NO. 1 CHAIN TENSIONER ASSEMBLY

a.
A326329

Visually check the seal portion of the No. 1 chain tensioner assembly for oil leakage.

HINT:

If there is only the faintest trace of oil on the seal on the push rod side, the No. 1 chain tensioner assembly is all right.


If leakage is found, replace the No. 1 chain tensioner assembly.


b.
A326330

Hold the No. 1 chain tensioner assembly with both hands and push the push rod strongly as shown to check that is doesn't move.

If the push rod is moves, replace the No. 1 chain tensioner assembly.


c.
A326331C01
2.927,0.375 3.146,0.573 0.219,0.198 10 false *a
*a Protrusion


Measure the protrusion of the push rod from the housing end.

Protrusion:

7.5 to 8.0 mm (0.295 to 0.315 in.)


If the protrusion is not specified, replace the No. 1 chain tensioner assembly.