Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER HEAD
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133480 CYLINDER HEAD A

1HZ ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.

·

Take off the cutter gradually to make the valve seat smooth.



a.
A329220C01
1.458,1.219 1.771,1.375 0.313,0.156 10 false *a
*a Width


Check the valve seating position.

i.

Apply a light coat of Prussian blue to the valve face.


ii.

Lightly press the valve against the seat. Do not rotate valve.


iii.

If blue appears 360° around the face, the valve is concentric. If not, replace the valve.


iv.

If blue appears 360° around the valve seat, the guide and face are concentric. If not, resurface the seat.


v.

Check that the seat contact is the middle of the valve face with the width below.

Standard Width:
Item Specified Condition
Intake valve seat 1.5 to 1.9 mm (0.0591 to 0.0748 in.)
Exhaust valve seat 1.8 to 2.2 mm (0.0709 to 0.0866 in.)




b.
A326297C01
2.771,1.719 3.083,1.875 0.313,0.156 10 false *a 3.042,0.698 3.323,0.896 0.281,0.198 10 false 25° 2.448,0.729 2.667,0.896 0.219,0.167 10 true 45°
*a Width


If the seating is too high on the valve face, use 25° and 45° cutters to correct the seat.


c.
A326298C01
2.781,1.708 2.979,1.896 0.198,0.188 10 false *a 2.469,0.688 2.74,0.969 0.271,0.281 10 false *b 2.938,0.521 3.198,0.719 0.26,0.198 10 false 45°
*a Width
*b for Intake Side: 70°
for Exhaust Side: 60°


for intake side:

If the seating is too low on the valve face, use 70° and 45° cutters to correct the seat.


d.

for exhaust side:

If the seating is too low on the valve face, use 60° and 45° cutters to correct the seat.


e.

Hand-lap the valve and valve seat with an abrasive compound.


f.

Clean the valve and valve seat.