Home › Engine / Hybrid System › 1HZ (ENGINE MECHANICAL) › CYLINDER BLOCK
RM25T0E _51 Engine / Hybrid System _029355 1HZ ENGINE MECHANICAL _0133481 CYLINDER BLOCK A

1HZ ENGINE MECHANICAL  CYLINDER BLOCK  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE CONNECTING ROD SMALL END BUSH

a.
A321634N01
1.042,0.458 1.25,0.458 1.25,0.458 1.719,0.74 false 0.729,0.385 1.073,0.552 0.344,0.167 10 false SST

Using SST and a press, press out the connecting rod small end bushing.

SST
09222-66010  


b.
A321635

Using a round file, lightly file off any roughness from the small end of the connecting rod.


c.
A326256C01
2.448,1.969 2.938,1.635 2.938,1.635 2.427,1.385 true 1.521,0.313 1.844,0.313 true 0.958,1.896 1.188,1.896 1.188,1.896 1.458,1.51 true 1.875,0.219 2.094,0.417 0.219,0.198 10 false *a 2.979,1.542 3.219,1.75 0.24,0.208 10 false *b 0.781,1.802 0.979,1.99 0.198,0.188 10 false *a
*a Front Mark
*b Align


Align the oil holes of the connecting rod small end bush and connecting rod.


d.
A321634N01
1.042,0.458 1.25,0.458 1.25,0.458 1.719,0.74 false 0.729,0.385 1.073,0.552 0.344,0.167 10 false SST

Using SST and a press, press in the connecting rod small end bush.

SST
09222-66010  


e.
A326257

Using a pin hole grinder, hone the connecting rod small end bush to obtain the clearance between the connecting rod small end bush and piston pin.


f.

Check the piston pin fit at normal room temperature.

i.

Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.