28120 1.REMOVE STARTER YOKE ASSEMBLY
Remove the nut and disconnect the lead wire from terminal C.
Remove the 2 bolts.
Pull out the starter yoke assembly and starter commutator end frame together with the starter armature assembly.
Remove the O-ring from the starter yoke assembly.
28140 2.REMOVE STARTER BRUSH HOLDER ASSEMBLY
Remove the 2 screws, and then remove the starter commutator end frame from the starter yoke assembly.
While holding down the lead wire, remove the starter commutator end frame.
Remove the O-ring from the starter yoke assembly.
Disconnect the 4 brushes from the starter brush holder assembly.
Using a screwdriver, hold back the brush spring.
Disconnect the brush from the brush holder.
Remove the starter brush holder assembly.
28160 3.REMOVE STARTER ARMATURE ASSEMBLY
Remove the starter armature assembly from the starter yoke assembly.
Turn the armature bearing and check that the armature bearing rotates smoothly and quietly.
28150 4.REMOVE MAGNET STARTER SWITCH ASSEMBLY
Remove the 2 screws and magnet starter switch assembly from the starter drive housing assembly.
Remove the idle gear, retainer, clutch roller, return spring and starter clutch sub-assembly from the starter drive housing assembly.
| *1 | Starter Drive Housing Assembly | *2 | Starter Clutch Sub-assembly |
| *3 | Idle Gear | *4 | Retainer |
| *5 | Clutch Roller | *6 | Return Spring |
| *a | Magnet Hand |
Using a magnet hand, remove the steel ball from the starter clutch sub-assembly hole.