1.INSPECT FOR COOLANT LEAK
Do not remove the radiator cap while the engine and radiator assembly are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap.
Fill the radiator assembly with engine coolant and attach a radiator cap tester.
Do not substitute plain water for engine coolant.
Warm up the engine.
Using the radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
Remove the radiator cap tester.
Install the radiator cap.
2.CHECK ENGINE COOLANT LEVEL IN RESERVOIR
Check that the engine coolant level is between the "LOW" and "FULL" line when the engine is cold.
If the engine coolant is low, check for leaks and add "TOYOTA Super Long Life Coolant" or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite and non-borate coolant with long-life hybrid organic acid technology to the "FULL" line.
Do not substitute plain water for engine coolant.
3.CHECK ENGINE COOLANT QUALITY
Do not remove the radiator cap while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Remove the radiator cap.
Check if there are any excessive deposits of rust or scales around the radiator cap and radiator filler hole. Also, the engine coolant should be free of oil.
If excessively dirty, clean the engine coolant passage and replace the engine coolant.
Install the radiator cap.