Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › MONOLITHIC CONVERTER(w/o DPF)
RM25T0E _51 Engine / Hybrid System _029525 1VD-FTV EMISSION CONTROL _0133832 MONOLITHIC CONVERTER A

1VD-FTV EMISSION CONTROL  MONOLITHIC CONVERTER  INSTALLATION  


PROCEDURE

Hide 18431 1.INSTALL UPPER CATALYTIC CONVERTER INSULATOR

a.

Install the upper catalytic converter insulator with the 2 bolts and nut.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 18450A 2.INSTALL MONOLITHIC CONVERTER ASSEMBLY

a.

Temporarily install a new gasket to the monolithic converter assembly by hand.

HINT:

Be sure to install the gasket as evenly as possible.



b.
A104635C20
2.698,1.01 2.917,0.583 2.917,0.583 3.083,0.583 false 1.5,0.167 1.667,0.167 1.667,0.167 2.146,0.49 true 1.333,0.083 1.646,0.24 0.313,0.156 10 false *1 3.104,0.5 3.417,0.656 0.313,0.156 10 false *a
*1 Gasket
*a Wooden Block


Using a plastic-faced hammer and wooden block, tap the gasket onto the monolithic converter assembly so that the gasket is flush with the pipe end.

NOTICE:
·

Install the gasket in the correct direction.

·

Do not damage the outer surface of the gasket.

·

Do not reuse the gasket.

·

Do not push in the gasket with the exhaust pipe when connecting it.




c.
A162138

Install a new gasket onto the turbine outlet elbow.


d.
A166035

Loosely install the monolithic converter assembly with the 3 new nuts.

HINT:

Tighten the nuts until the contact surface of the monolithic converter assembly contacts with the turbine outlet elbow.



e.

Loosely install the center converter protector stay with the 3 bolts.

HINT:

Tighten the bolts so that the position of the monolithic converter assembly can be adjusted in a later step.



f.

Tighten the 3 nuts of the monolithic converter assembly.

Torque:
47 N*m (479 kgf*cm, 35 ft.*lbf)


g.

Tighten the 3 bolts of the center converter protector stay.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


h.

Inspect the compression spring.

i.

Using a vernier caliper, measure the free length of the compression spring.

Standard free length:

43 mm (1.69 in.)


If the free length is not as specified, replace the compression spring.



i.
A162131C01
0.833,2.083 1.146,2.24 0.313,0.156 10 false *a 2,2.083 2.313,2.24 0.313,0.156 10 false *b
*a CORRECT
*b INCORRECT


Connect the monolithic converter assembly to the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

NOTICE:
·

When tightening the bolts, make sure the lengths of the springs are approximately the same.

·

Make sure the joint part is movable.

·

Make sure the bolts do not get caught on the flange.




Hide 53737B 3.INSTALL FRONT FENDER APRON SEAL LH

a.

Install the front fender apron seal LH with the 11 clips.