1. PRECAUTION
After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28800 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51442 3.REMOVE NO. 2 ENGINE UNDER COVER
16361A 4.REMOVE FAN AND GENERATOR V BELT
27280 5.REMOVE GENERATOR SPLASH GUARD COVER ASSEMBLY
Disconnect the wire harness clamp from the generator splash guard cover assembly.
Remove the 3 bolts and generator splash guard cover assembly from the generator assembly.
27020 6.REMOVE GENERATOR ASSEMBLY
Disconnect the generator connector.
Remove the terminal cap and nut, and disconnect the generator wire.
Remove the 3 bolts and 2 nuts.
Using an E7 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.