89661 1.REMOVE ECM
| *a | Lock |
| *b | Push |
Open the 2 levers while pushing the locks on the 2 levers.
Make sure that the lock levers are opened 90° as shown in the illustration before disconnecting the ECM connectors. Failure to do this may cause the ECM connectors to break.
Disconnect the 2 connectors.
Remove the 4 bolts and ECM.
89664A 2.REMOVE GASKET
Peel off the gasket.
| *a | Cloth |
Spray gasket remover or equivalent on the remaining gasket tape.
When using gasket remover or equivalent, cover the ECM connectors with a cloth.
Remove the gasket tape without using bladed objects.