Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › ACCELERATOR PEDAL
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135333 ACCELERATOR PEDAL A

1GR-FE ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78110K 1.INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.


a.

Install the accelerator pedal sensor assembly with the 2 nuts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Connect the accelerator pedal sensor connector.