Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › MASS AIR FLOW METER
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135334 MASS AIR FLOW METER G

1GR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
A162734C05
1.427,2.438 1.281,2.438 1.281,2.438 1.146,1.823 true 0.417,2.25 0.531,2.25 0.531,2.25 0.781,1.49 true 1.479,2.344 1.677,2.521 0.198,0.177 10 false *a 0.219,2.167 0.417,2.344 0.198,0.177 10 false *b
*a Platinum Hot Wire (Heater)
*b Temperature Sensor (Thermistor)


Perform a visual check for any foreign matter on the platinum hot wire (heater) and temperature sensor (thermistor) of the mass air flow meter shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, clean the mass air flow meter.


b.

Check the intake air temperature sensor (thermistor) resistance.

i.
A328407C03
0.99,0.438 1.094,0.438 1.094,0.438 1.375,1.177 true 1.563,1.177 1.875,0.469 1.875,0.469 1.99,0.469 true 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 1.969,1.188 2.125,1.385 0.156,0.198 10 false 1 1.823,1.188 1.979,1.385 0.156,0.198 10 false 2 1.677,1.188 1.833,1.385 0.156,0.198 10 false 3 1.521,1.188 1.677,1.385 0.156,0.198 10 false 4 1.365,1.188 1.521,1.385 0.156,0.198 10 false 5 0.771,0.396 1.083,0.594 0.313,0.198 10 false E2 2.052,0.406 2.365,0.604 0.313,0.198 10 false THA
*a Component without harness connected
(Mass Air Flow Meter)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (THA) - 5 (E2) Always 0.47 to 19.3 kΩ


If the result is not as specified, replace the mass air flow meter.