Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › 2014.08–2021.12
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135343 SFI SYSTEM U

1GR-FE ENGINE CONTROL  SFI SYSTEM  FAIL-SAFE CHART  


If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

DTCs Component Fail-Safe Operation Fail-Safe Deactivation Condition
P0031, P0032, P0051 and P0052 Air fuel ratio sensor heater The ECM turns off the A/F sensor heater. Ignition switch off
P0037, P0038, P0057 and P0058 Heated oxygen sensor heater The ECM turns off the heated oxygen sensor heater. Ignition switch off
P0102, P0103 Mass air flow meter The ECM calculates the ignition timing according to the engine speed and throttle valve position. Pass condition detected
P0112, P0113 Intake air temperature sensor The ECM estimates the intake air temperature to be 20°C (68°F). Pass condition detected
P0115, P0117 and P0118 Engine coolant temperature sensor The ECM estimates the engine coolant temperature to be 80°C (176°F). Pass condition detected
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P060A, P060D, P060E, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135 Electronic Throttle Control System (ETCS) The ECM cuts off the throttle actuator current and the throttle valve returns to 6° throttle position by the return spring.
The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal opening angle, to allow the vehicle to continue at minimal speed.*
Pass condition detected and then ignition switch turned off
P0327, P0328, P0332 and P0333 Knock Sensor The ECM sets the ignition timing to maximum retard. Ignition switch off
P0351 to P0356 Ignition coil assembly The ECM cuts the fuel. Pass condition detected
P0504 Stop light switch assembly The accelerator pedal opening angleis fixed when there is a acceleratorpedal malfunction or history of a malfunction Pass condition detected
P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138 Accelerator pedal position sensor The accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, the ECM limits the engine output.
If both of the circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve is closed and the engine idles.
Pass condition detected and then ignition switch turned off
P2237, P2238, P2239, P2240, P2241, P2242, P2243, P2252, P2253, P2255 and P2256 Air fuel ratio sensor
·

Air fuel ratio feedback controlis stopped.

·

Current to the air fuel ratio sensor heater is cut.


Pass condition detected and then ignition switch turned off

HINT:

*: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.