DESCRIPTION
Freeze frame data records the engine conditions (fuel system, calculated load, engine coolant temperature, fuel trim, engine speed, vehicle speed, etc.) when a malfunction is detected. When troubleshooting, it can help determine if the vehicle was moving or stationary, the engine was warmed up or not, the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
If it is impossible to duplicate the problem even though a DTC is output, confirm the freeze frame data.
The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.
3 data sets before the DTC was stored.
1 data set when the DTC was stored.
1 data set after the DTC was stored.
These data sets can be used to simulate the condition of the vehicle around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.
LIST OF FREEZE FRAME DATA
| Tester Display |
|---|
| Vehicle Speed |
| Engine Speed |
| Calculate Load |
| Vehicle Load |
| MAF |
| Atmosphere Pressure |
| Coolant Temp |
| Intake Air |
| Engine Run Time |
| Initial Engine Coolant Temp |
| Initial Intake Air Temp |
| Battery Voltage |
| Accel Sens. No.1 Volt % |
| Accel Sens. No.2 Volt % |
| Throttle Sensor Volt % |
| Throttl Sensor #2 Volt % |
| Throttle Sensor Position |
| Throttle Motor DUTY |
| Throttle Position |
| ISC Flow |
| ISC Position |
| ISC Feedback Value |
| ISC Learning Value |
| Electric Load Feedback Val |
| Air Conditioner FB Val |
| PS Feedback Val |
| N Range Status |
| Injector (Port) |
| Injection Volum (Cylinder1) |
| Fuel Pump Speed Control |
| Fuel Pump/Speed Status |
| EVAP (Purge) VSV |
| Evap Purge Flow |
| Purge Density Learn Value |
| EVAP Purge VSV |
| Target Air-Fuel Ratio |
| AF Lambda B1S1 |
| AF Lambda B2S1 |
| AFS Voltage B1S1 |
| AFS Voltage B2S1 |
| AFS Current B1S1 |
| AFS Current B2S1 |
| O2S B1S2 |
| O2S B2S2 |
| Short FT #1 |
| Long FT #1 |
| Short FT #2 |
| Long FT #2 |
| Fuel System Status #1 |
| Fuel System Status #2 |
| IGN Advance |
| Knock Feedback Value |
| Knock Correct Learn Value |
| ACIS VSV |
| VVT Control Status #1 |
| VVT Control Status #2 |
| VVT Advance Fail |
| Catalyst Temp B1S1 |
| Catalyst Temp B2S1 |
| Catalyst Temp B1S2 |
| Catalyst Temp B2S2 |
| Starter Signal |
| Power Steering Signal |
| Power Steer. Sig. Record |
| Stop Light Switch |
| A/C Signal |
| Closed Throttle Position SW |
| Fuel Cut Condition |
| Immobiliser Communication |
| Electrical Load Signal |
| Time after DTC Cleared |
| Distance from DTC Cleared |
| Warmup Cycle Cleared DTC |
| TC and TE1 |
| Previous Trip Coolant Temp |
| Previous Trip Intake Temp |
| Fuel Cut Elps Time |
| ACT VSV |
| Idle Fuel Cut |
| FC TAU |
| Immobiliser Fuel Cut |