Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135343 SFI SYSTEM D

1GR-FE ENGINE CONTROL  SFI SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from the normal mode to check mode or vice versa, all DTCs and freeze frame data stored in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be output to the GTS. The GTS can display the current and pending DTCs.

·

Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Check the DTC(s) and freeze frame data, and then write them down.




CLEAR DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Clear the DTCs.



CLEAR DTC (Without using the GTS)


a.

Perform either of the following operations:

i.
A221922C01
1.74,2.313 2.167,2.104 true 1.74,2.688 2.167,2.885 true 2.229,2.854 2.646,3.031 0.417,0.177 10 false *3 2.208,2.021 2.49,2.198 0.281,0.177 10 false *2 0.271,0.25 0.583,0.448 0.313,0.198 10 false *1
*1 Fuse Block Assembly
*2 EFI
*3 ETCS


Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI and ETCS fuses from the Fuse Block Assembly located inside the engine compartment for more than 1 minute.