Home › Engine / Hybrid System › 1HZ (ENGINE CONTROL) › ECD SYSTEM
RM25T0E _51 Engine / Hybrid System _029759 1HZ ENGINE CONTROL _0135351 ECD SYSTEM U

1HZ ENGINE CONTROL  ECD SYSTEM  FAIL-SAFE CHART  


If any of the following codes is recorded, the emission control ECU enters fail-safe mode.

DTC No. Detection Item Fail-Safe Operation Fail-Safe Deactivation Condition
13 Engine Speed Sensor Circuit Malfunction (NE Circuit)
·

Engine speed 0 rpm

·

EGR OFF

·

VSV for EGR cut and VSV for BACS OFF


Returned to normal condition
22 Engine Coolant Temperature Sensor Circuit Malfunction
·

Engine coolant temperature is fixed at -20°C (-4°F)

·

EGR OFF

·

VSV for EGR cut and VSV for BACS OFF


Returned to normal condition
31 Vacuum Sensor Circuit
·

Intake air pressure 101.3 kPa (760 mmHg, 30 in.Hg)

·

EGR OFF

·

VSV for EGR cut and VSV for BACS OFF


Returned to normal condition
41 Throttle Position Sensor Circuit
·

Accelerator pedal position is fixed at 0%

·

EGR OFF

·

VSV for EGR cut and VSV for BACS OFF


The following condition must be repeated at least 2 times consecutively when closed throttle position switch is ON:
VA is 0.1 V or higher and 4.85 V or less
42 Vehicle Speed Sensor Signal Circuit Malfunction A/C cut does not operate Returned to normal condition
43 Starter Signal Circuit Malfunction Starter OFF Returned to normal condition
71 EGR System Malfunction
·

EGR OFF

·

VSV for EGR cut and VSV for BACS OFF


·

+B 11 V

·

E-VRV for EGR OFF (EGR is cut)