1.CHECK FOR COMPENSATION CODE
When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM and the learned value of the supply pump assembly must be input.
Using the GTS, check that the ID codes registered in the injector assemblies installed on each cylinder match the ECM.
If the codes do not match, correct the registered data and recheck the problem symptom by following the steps below.
Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>PRECAUTION
Using GTS, manually correct the registered ID code.
Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>PRECAUTION
Check if the same symptom occurs, when the vehicle was brought in.
If the symptom does not occur, the problem may be caused by misregistration of an ID code.
2. PRECAUTION
After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery teminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
89661 4.REMOVE ECM
| *a | Lock |
| *b | Push |
Raise the 2 levers while pushing the locks on the 2 levers.
Disconnect the 2 connectors.
Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.
Remove the 4 bolts and ECM.
Remove the gasket.
Peel off the gasket.
Spray gasket remover or equivalent on the remaining tape of the gasket.
When using gasket remover or equivalent, cover the connector with a cloth.
Remove the tape of the gasket without using bladed objects.