Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135353 DIESEL THROTTLE BODY G

1VD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 26100G 1.CHECK DIESEL THROTTLE BODY ASSEMBLY

a.

Inspect the diesel throttle valve.

i.

Turn the ignition switch to ON.


ii.

Turn the ignition switch off and wait 5 seconds.

HINT:

Be sure to turn off the ignition switch before performing this inspection. The fully closed position of the diesel throttle valve is learned when the ignition switch is turned off.



iii.

Connect the GTS to the DLC3.


iv.

Turn the GTS.


v.

Turn the GTS on.


vi.

Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Volt % and Throttle Sensor #2 Volt %.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Sensor Volt %
Throttl Sensor #2 Volt %
50003 61 320,74

vii.

Check that the value of "Throttle Sensor Volt %, Throttle Sensor #2 Volt %" is within the specification.

Standard Value:
Tester Display Specified Condition
Throttle Sensor Volt % 60 to 80%
Throttle Sensor #2 Volt %


If the result is not as specified, replace the diesel throttle body assembly.