Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135355 CRANKSHAFT POSITION SENSOR G

1VD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11301K 1.INSPECT CRANKSHAFT POSITION SENSOR

A329150C01
2.323,1.656 2.865,1.656 true 0.927,1.646 1.469,1.646 true 0.094,0.063 0.354,0.292 0.26,0.229 10 false *a 0.563,1.563 0.917,1.75 0.354,0.188 10 false NE+ 2.948,1.583 3.302,1.771 0.354,0.188 10 false NE-
*a Component without harness connected
(Crankshaft Position Sensor)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (NE+) - 2 (NE-) Cold 1630 to 2740 Ω
1 (NE+) - 2 (NE-) Hot 2065 to 3225 Ω


NOTICE:

In the table above, the terms "Cold" and "Hot" refer to the temperature of the crankshaft position sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.