After replacing the fuel supply pump and/or the ECM:
If the engine is defective or stalls immediately after startup, the ECM's learned values must be initialized. The engine can be initialized through the GTS or by connecting the DLC3 terminals.
If the engine starts normally, initialization is not necessary. Perform the step "idle the engine" procedure below only.
FUEL SUPPLY PUMP INITIALIZATION PROCEDURE
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Do not start the engine.
Turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Utility / Supply Pump Initialization.
Press "Next".
Press "Next".
Press "Exit".
Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning.
Idle the engine for at least 1 minute under the following conditions:
The engine coolant temperature is 60°C (140°F) or more.
The fuel temperature is 20°C (68°F) or more.
Do not race the engine immediately after starting the engine. After warming up the engine, racing the engine is acceptable.
If the engine coolant temperature is difficult to estimate, use the GTS and enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp and Fuel Temperature.
Initialization is complete.