Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135361 MANIFOLD ABSOLUTE PRESSURE SENSOR G

1VD-FTV ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421C 1.CHECK DIESEL TURBO PRESSURE SENSOR

A163538C05
0.833,2.115 1.333,2.115 true 2.125,2.115 2.625,2.115 true 0.073,0.052 0.396,0.271 0.323,0.219 10 false *a 0.594,2.031 0.917,2.26 0.323,0.229 10 false E2 2.708,2.042 3.021,2.271 0.313,0.229 10 false VC
*a Front view of wire harness connector
(to Diesel Turbo Pressure Sensor)


a.

Inspect the power source voltage.

i.

Disconnect the connector from the diesel turbo pressure sensor.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T25-3 (VC) - T25-1 (E2) Ignition switch ON 4.75 to 5.25 V



iii.

Turn the ignition switch off.


iv.

Reconnect the diesel turbo pressure sensor connector to the diesel turbo pressure sensor.



b.

Check the vacuum and pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS on.


iii.

Enter the following menus: Power train / Engine and ECT / Data List / Map and Atmosphere Pressure.

Powertrain > Engine and ECT > Data List
Tester Display
Atmosphere Pressure
MAP
50003 61 64,314

iv.

Read the value.

OK:
Condition Map Value
No pressure applied Same as atmospheric pressure
Vacuum applied Becomes vacuum
Pressure applied Becomes pressurized


If the result is not as specified, replace the diesel turbo pressure sensor.