1.INSPECT EFI RELAY (EFI MAIN1, EFI MAIN2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | battery voltage is not applied between 1 and 2 | 10 kΩ or higher |
| 3 - 5 | battery voltage is applied between 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the EFI relay.
2.INSPECT EDU RELAY (EDU1, EDU2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | battery voltage is not applied between 1 and 2 | 10 kΩ or higher |
| 3 - 5 | battery voltage is applied between 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the EDU relay.