1.INSPECT FUEL PRESSURE
Read Data List
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
| Tester Display |
|---|
| Target Common Rail Pressure |
| Fuel Press |
Read the Data List.
| Tester Display | Measurement Item/Range (Display) | Normal Conditions |
|---|---|---|
| Fuel Press | Fuel pressure / Min.: 0 kPa, Max.: 655350 kPa | 27000 to 37000 kPa: Idling |
| Target Common Rail Pressure | Target common rail pressure/ Min.: 0 kPa, Max.: 655350 kPa | 25000 to 180000 kPa |
2.INSPECT FOR FUEL LEAK
Perform Active Test
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
| Tester Display |
|---|
| Test the Fuel Leak |
Perform the Active Test.
| Tester Display | Test Details | Control Range | Diagnostic Notes |
|---|---|---|---|
| Test the Fuel Leak | Pressurizes fuel inside common rail and checks for fuel leaks | Stop/Start |
·
Fuel inside common rail pressurized to specified value and engine speed increased to 2000 rpm when Start is selected
·
Above conditions preserved while test is Start |
3. BLEED AIR FROM FUEL SYSTEM
Using the hand pump indicated by the arrow in the illustration, bleed air from the fuel system. Continue pumping until pumping becomes difficult.
4.CHECK FUEL FILTER WARNING LIGHT AND DRAIN WATER
Check the fuel filter warning light.
When the fuel filter warning light illuminates and the buzzer sounds, the water in the fuel filter must be drained immediately.
Connect a hose to the fuel filter drain plug.
| *a | Container |
Loosen the fuel filter drain plug and place a container to catch the water.
Operate the hand pump until only fuel begins to run out.
After draining, tighten the fuel filter drain plug.
Do not use any tools.