Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL FILTER
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135398 FUEL FILTER G

1VD-FTV FUEL  FUEL FILTER  INSPECTION  


PROCEDURE

Hide 1.INSPECT LEVEL WARNING SWITCH

A167573C01
0.104,0.094 0.375,0.333 0.271,0.24 10 false *a
*a Component without harness connected
(Level Warning Switch)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float upper end position Below 1 Ω
1 - 2 Float lower end position 1 MΩ or higher


If the result is not as specified, replace the fuel filter case.


Hide 2.INSPECT CLOGGING SWITCH

A167574C01
0.115,0.125 0.396,0.344 0.281,0.219 10 false *a
*a Component without harness connected
(Clogging Switch)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) Below 1 Ω


If the result is not as specified, replace the fuel filter cap assembly.