Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL FILTER
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135398 FUEL FILTER A

1VD-FTV FUEL  FUEL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

When replacing the fuel filter element assembly, use TOYOTA genuine parts or equivalent parts.


PROCEDURE

Hide 1.DRAIN FUEL FROM FUEL FILTER

a.
A272342C01
2.146,2.969 1.677,3.167 1.677,3.167 1.542,3.167 false 1.323,3.083 1.521,3.24 0.198,0.156 10 false *a
*a Container


Connect a hose to the fuel filter drain plug. Place the other side of the same hose into a container.


b.

Loosen the fuel filter drain plug to drain fuel.


c.

Tighten the fuel filter drain plug.


Hide 23390 2.REMOVE FUEL FILTER ELEMENT ASSEMBLY

a.
A272343

Disconnect the clogging switch connector.


b.

Slide the 2 clamps and disconnect the 2 fuel hoses from the fuel filter cap assembly.


c.
A272344

Using a 5 mm hexagon socket wrench, remove the 3 bolts and fuel filter cap assembly.


d.
A272346

Remove the O-ring and retainer.


e.
A272347

Remove the fuel filter element assembly from the fuel filter case.

NOTICE:

Do not damage the fuel filter element assembly and fuel filter case.



f.
A272345

Disconnect the water level warning sensor connector.


g.

Detach the clamp and remove the fuel filter case.


Hide 23390 3.INSTALL FUEL FILTER ELEMENT ASSEMBLY

a.

Connect the water level warning sensor connector.


b.

Attach the clamp and install the fuel filter case.


c.

Install the fuel filter element assembly to the fuel filter case.

NOTICE:
A272349C01
0,0 0,0 false
V100144

No Foreign Matter


Make sure that there is no foreign matter on the areas of the fuel filter case shown in the illustration.



d.
A272348

Install the retainer and a new O-ring.

NOTICE:

Make sure to install the O-ring with the rounded side facing upward and the retainer as shown in the illustration.



e.

Using a 5 mm hexagon socket wrench, install the fuel filter cap assembly with the 3 bolts.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)

NOTICE:
A272350C01
0,0 0,0 false
V100144

No Foreign Matter


·

Make sure that there is no foreign matter on the areas of the fuel filter cap assembly shown in the illustration.

·

Do not turn the fuel filter cap assembly as the O-ring will be damaged.



HINT:

Further tighten the first bolt tightened above so that its torque value is slightly more than the torque specification.



f.

Connect the 2 fuel hoses to the fuel filter cap assembly, and slide the 2 clamps to secure the hoses.


Hide 4.RESET FUEL SYSTEM WARNING LIGHT

a.

Turn the ignition switch to ON.


b.
A272351

After turning the ignition switch to ON, connect the clogging switch connector within 3 to 60 seconds.


c.

Check that the combination meter's fuel system warning light turns off.


Hide 5.BLEED AIR FROM FUEL SYSTEM

A272352

a.

Using the hand pump, bleed air from the fuel system until pumping becomes difficult.


Hide 6.INSPECT FOR FUEL LEAK

a.

Start the engine. Check that leaking sounds, sucking sounds or other unusual sounds cannot be heard.