Home › Engine / Hybrid System › 1VD-FTV (FUEL) › FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank) › 2014.08–2016.08
RM25T0E _51 Engine / Hybrid System _029770 1VD-FTV FUEL _0135411 FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank) G

1VD-FTV FUEL  FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank)  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

A289049C01
1.021,4.396 0.521,4.396 false 0.885,1.917 0.323,1.917 false 0.104,0.104 0.281,0.292 0.177,0.188 10 false *a 0.177,1.833 0.313,2 0.135,0.167 10 false F 0.354,4.313 0.49,4.479 0.135,0.167 10 false E
*a Component without harness connected
(Fuel Sender Gauge Assembly)


a.

Check the fuel sender gauge resistance.

i.

Check that the float moves smoothly between the F (upper end) and E (lower end) levels.


ii.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 3 F (Upper End) 12 to 18 Ω
1 - 3 E (Lower End) 405 to 415 Ω


If the result is not as specified, replace the fuel sender gauge assembly.