Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0135612 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  CHECK FOR INTERMITTENT PROBLEMS  


CHECK FOR INTERMITTENT PROBLEMS


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECU can be detected using the ECU Data List function of the GTS.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.


f.

Select areas where momentary interruptions should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

·

If Error is displayed, measure the resistance between the ECU and sensors.

·

Error remains displayed on the GTS for 1 second after the harness signal changes from a momentary interruption (open circuit) to normal.



Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Speed Open Front speed sensor RH open detection Error or Normal Normal -
FL Speed Open Front speed sensor LH open detection Error or Normal Normal -
RR Speed Open Rear speed sensor RH open detection Error or Normal Normal -
RL Speed Open Rear speed sensor LH open detection Error or Normal Normal -
Deceleration Open Deceleration sensor open detection Error or Normal Normal -
IG Voltage Value Decreased IG voltage value decrease detection Error or Normal Normal -
IG Voltage Value Increased IG voltage value increase detection Error or Normal Normal -
FR Speed Sensor Voltage Open Front speed sensor RH voltage open detection Error or Normal Normal -
FL Speed Sensor Voltage Open Front speed sensor LH voltage open detection Error or Normal Normal -
RR Speed Sensor Voltage Open Rear speed sensor RH voltage open detection Error or Normal Normal -
RL Speed Sensor Voltage Open Rear speed sensor LH voltage open detection Error or Normal Normal -

g.

While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors.

OK:

Normal display does not change.


HINT:

If the display changes, the connector and/or wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness as one of them is faulty.