Home › Engine / Hybrid System › 1GR-FE (COOLING) › THERMOSTAT
RM25T0E _51 Engine / Hybrid System _029895 1GR-FE COOLING _0136490 THERMOSTAT G

1GR-FE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16031 1.INSPECT WATER INLET WITH THERMOSTAT

HINT:
A174313

The valve opening temperature is inscribed on the thermostat.


a.

Immerse the thermostat in water, and then gradually heat the water.


b.

Check the valve opening temperature of the thermostat.

Standard valve opening temperature:

80 to 84°C (176 to 183°F)


If the valve opening temperature is not as specified, replace the water inlet with thermostat.


c.
A174314C04
2.229,1.656 2.438,1.865 0.208,0.208 10 false *a
*a Valve Lift


Check the valve lift.

Standard valve lift:

8.0 mm (0.315 in.) or more at 95°C (203°F)


If the valve lift is not as specified, replace the water inlet with thermostat.


d.

Check that the valve is fully closed when the water inlet with thermostat is at a low temperature (below 77°C (171°F)).

If the valve is not fully closed, replace the water inlet with thermostat.