Home › Engine / Hybrid System › 1HZ (FUEL) › FUEL INJECTION PUMP
RM25T0E _51 Engine / Hybrid System _029893 1HZ FUEL _0136493 FUEL INJECTION PUMP G

1HZ FUEL  FUEL INJECTION PUMP  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
A333895

Do not touch the sliding surfaces of the pump plunger and delivery valves.


PROCEDURE

Hide 1.INSPECT DELIVERY VALVES

a.
A333896

Pull up the valve and close the hole at the valve seat bottom end with your thumb.

When the valve is released, it should sink down quickly and stop at the position where the relief ring closes the valve seat hole.


b.
A333897

Close the hole at the valve seat bottom end with your thumb.

Insert the valve into the valve seat and press down with your finger. When your finger is released, the valve should rise back to its original position.


c.
A333898

Remove your thumb from the valve seat hole.

The valve should close completely by its own weight.

If operation is not as specified, replace the valve as a set.

HINT:

Before using a new valve set, wash off the rust prevention compound with light oil or gasoline. Then re-wash with diesel fuel and perform the above tests.



Hide 2.INSPECT PUMP PLUNGER, SPILL RING AND DISTRIBUTIVE HEAD

a.
A333899

Tilt the spill ring (distributive head) slightly and pull out the plunger.


b.

When released, the plunger should sink down smoothly into the spill ring (distributive head) by its own weight.


c.

Rotate the plunger and repeat the test at various positions.

If the plunger sticks at any position, replace the parts as a set.


d.
A333900

Insert the governor link ball pin into the spill ring and check that it moves smoothly without any play.


Hide 3.INSPECT PLUNGER SPRINGS FOR SQUARENESS

a.
A101393C15
2,0.125 2.208,0.302 0.208,0.177 10 false *a
*a Squareness


Using a steel square, check the squareness of the plunger springs.

Maximum squareness:

2.0 mm (0.0787 in.)


If squareness is more than the maximum, replace the springs.


Hide 4.INSPECT SPRING LENGTH

a.
A101392

Using a vernier caliper, measure the free length of each spring.

Spring free length:
Delivery valve spring:

24.4 mm (0.961 in.)

Pneumatic bellows spring (w/ HAC):

35.0 mm (1.38 in.)


If the free length is not specified, replace the spring(s).


Hide 5.INSPECT ROLLER RING AND ROLLERS

a.
A333901

Using a dial indicator, measure the roller height.

Roller height variation:

0.02 mm (0.000787 in.)


If the roller height is more than the maximum, replace the springs.


Hide 22390A 6.INSPECT FUEL CUT SOLENOID

a.
A333902

Connect the solenoid valve body and terminal to the battery terminals.


b.

You should feel the click from the solenoid valve when the battery power is connected and disconnected.

If the solenoid valve is not operating properly, replace it.


Hide 7.INSPECT PICKUP SENSOR (w/ TACHOMETER)

a.
A333903C01
0.063,0.031 0.292,0.25 0.229,0.219 10 false *a
*a Component without harness connected
(Pickup Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 650 to 1020 Ω


If the result is not as specified, replace the pickup sensor.