Home › Engine / Hybrid System › 1HZ (FUEL) › FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank) › 2014.08–2016.08
RM25T0E _51 Engine / Hybrid System _029893 1HZ FUEL _0136505 FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank) A

1HZ FUEL  FUEL SENDER GAUGE ASSEMBLY(for 130 L Tank)  INSTALLATION  


PROCEDURE

Hide 83320 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

NOTICE:

If an fuel sender gauge assembly is removed from the fuel tank assembly, replace the fuel sender gauge assembly with a new one.


a.

Install a new fuel sender gauge assembly with the 5 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


b.

Attach the wire harness clamp to the fuel tank assembly.


c.

for Model Code #J76 Series:

Attach the wire harness clamp to the frame.


d.

for Model Code #J76 Series:

Connect the fuel sender gauge connector.


Hide 77100 2.INSTALL FUEL TANK ASSEMBLY (for Model Code #J79 Series)

Hide 58325E 3.INSTALL REAR FLOOR SERVICE HOLE COVER (for Model Code #J76 Series)

a.

Install the rear floor service hole cover with the 2 screws.


Hide 4.BLEED AIR FROM FUEL SYSTEM